Sunfab In-Line SLPD Dual Flow Pump SLPD-46/46W-V-DL4-L35-S4S-4

SLPD 20/20-64/32 DIN Savtec is equipped with a shut-off valve, this makes it possible to control so that oil only feeds when required. SLPD 20/20-64/32 DIN Savtec´s valve is available as pneumatic remote control. The signal is obtained from a panel switch or automatically from, e.g. the parking brake, pressure sensor or diode gate. With a closed Savtec valve it generates neither flow nor pressure, and in doing so does not load the power take-off. This has a positive effect on fuel economy. In some hydraulic systems such as a closed centre design, a certain amount of oil can flow into the pressure lines which after a time can build up pressure. We therefore recommend that the pressure line should always be unloaded to the tank. SLPD 20/20-64/32 DIN Savtec features extra lubrication ducts on the bearings for lubrication even when the pump is run with the Savtec-valve closed. The pump comes in eight different sizes, where three models feature differentiated flows. Pumps with differentiated flow increase the field of application as they can provide three different flows: one small, one large and one combined flow. Max pressure is 330- 350 bar depending on the model. Other advantages: • Independent direction of rotation • A cost effective total solution in relation to a conventional installation using two pumps in a splitter gear box • Smooth operation over the entire speed range • Long life due to high demands on material selection, such as bearings, seals, etc. • O-rings on all contact surfaces as well as double shaft seals eliminate oil leakage from the pump and power take-off • Extremely low noise emission over entire speed and pressure ranges • The Savtec valve can also be used as an emergency stop . SLPD-46/46W-V-DL4-L35-S4S-4 SLPD-20/20W-V-DL4-L35-S4S-4 SLPD-28/28W-V-DL4-L35-S4S-4 SLPD-40/20W-V-DL4-L35-S4S-4 SLPD-35/35W-V-DL4-L35-S4S-4 SLPD-56/28W-V-DL4-L35-S4S-4 SLPD-53/53W-V-DL4-L35-S4S-4 SLPD-64/32W-V-DL4-L35-S4S-4