HAWE V30E Series Hydraulic Pump

Overview: variable displacement axial piston pump type V30E

Hawe V30E Variable displacement axial piston pumps adjust the geometric output volume
from maximum to zero. As a result they vary the low rate that is provided to the
consumers.
The variable displacement axial piston pump type V30E is design for open circuits
in mobile hydraulics and operates according to the swash plate principle. It is
available with the option of a thru-shaft for operating with additional hydraulic
pumps in series.
The sturdy pump is particularly suitable for continuous operation in challenging
applications. The range of pump controllers allows the axial piston pump to use
in a variety of applications.

HAWE V30E Features and benefits

Low-noise
Broad selection of controllers
Full torque available at the second pump in tandem pump applications
Intended applications
Machines for forestry and agricultural purposes
Cranes and lifting equipment
Construction machines

Installation, operation and maintenance information

1. Intended use

This product is intend exclusively for hydraulic applications (fluid technology).
The user must observe the safety measures and warnings in this document.
Essential requirements for the product to function correctly and safely:
All information in this documentation must observe. This applies in particular to all safety measures and warnings.
The product must only assemble and put into operation by specialist personnel.
The product must only operate within the specified technical parameters describe in detail in this document.
All components must be suitable for the operating conditions when using an assembly.
The operating instructions for the components, assemblies and the specific complete system must also always be observed.
If the product can no longer operate safely:
1. Remove the product from operation and mark it accordingly.
✓ It is then not permitted to continue using or operating the product.

2 Assembly information

The product must only install in the complete system with standard and compliant connection components (screw fittings, hoses,
pipes, fixtures etc.).
The product must be shut down correctly prior to disassembly (in particular in combination with hydraulic accumulators).

2.1 General information

The variable displacement axial piston pump is suitable for use in an open circuit.
The pump can be mounted using a flange in accordance with specifications.
The various controllers can fit as intermediate plate versions or as separate devices as required.

During assembly, note the following principles:

Only trained persons are allowed to mount or remove the pump.
Always ensure absolute cleanliness to prevent contamination from affecting the pump.
Remove all plastic plugs before operation.
Avoid installation above the tank (see Chapter 5.2.3, "Installation positions").
Observe the electric reference values.
Before initial use, fill the pump with hydraulic fluid and bleed. Automatic pump filling via the suction line by opening the drain ports
is not possible.
Always supply the pump with hydraulic fluid from the start. Even just a short period with insufficient hydraulic fluid can damage the
pump. Such damage is not immediately visible once the pump is put into operation.
Never drain the pump.
Hydraulic fluid which flows back into the tank must not be sucked back in immediately (install baffles!)

V30E-095RDN-1-1-00/LLSN-250

V30E-095RKGN-1-0-02

V30E-095RKN-1-0-01/N-160

V30E-095RKN-2-1-01/LN-200

V30E160+V30E160

V30E-160RDN-1-0-01/LSN-250

V30E-160RDN-1-1-01/LLSN-180

V30E-160RDN-2-1-00/LLSN-250

V30E-160RKN-1-0-01-LLSN-2

V30E-160RSN-2-0-01/N-125

V30E-270RKN-1-1-00/N-250

V30E-95RKN-1-0-01N-140